185
Chapter 3 Features and Functions
Remote Interface Configuration
3
Current Configuration (LAN) Select the Currently Active Settings
display to view the MAC address and current LAN configuration.
• Front panel operation: Press and press I/O Config and LAN
Settings.
• There is no SCPI command to display the configuration screen.
Note: This display reflects only the settings that are currently active.
Also, this display is static. It does not update information for events that
have occurred after the information is displayed. For example, if DHCP
assigns an IP address while the display is open, you will not see the new
IP address.
If the instrument goes into remote, all LAN changes will be canceled, and
the display will go to a different screen. Re-selecting the LAN Settings
page will display the new settings if a LAN restart took place.
Additional SCPI Configuration Commands (LAN) There are some
additional LAN configuration commands, not covered here, that are
covered in the Agilent 33500 Series Programmer’s Reference Help.
To Next Page
Loading...
Need help?
General
