Agilent Technologies 5110 ICP-OES User Manual

Installation
Agilent 5100 and 5110 ICP-OES User’s Guide 29
 Green blinking slow (1 Hz). The mains power module is
initializing and running through power up self-check, or is
shutting off the instrument.
 Green blinking fast (4 Hz). Mains power module failed its
initialization power-up self-check, instrument is unusable. The
mains power supply is not adequate or the internal mains
module needs to be replaced.
 Green constantly on indicates the instrument is switched on.
ICP Expert Software
The Agilent-trained, Agilent-qualified or Agilent-authorized field
service engineer will install the ICP Expert software for you during
the installation process. However, you may need to install the
software yourself at some later stage, for example if you change the
PC. Instructions are provided.
There are several installation scenarios:
 Standalone or network Flat File
 Standalone or network Database for 21 CFR Part 11 installations
 Upgrading Standalone or Network Database ICP Expert
installations
Installation includes:
 Installing the ICP Expert software
 Installing the ICP Expert Help
 Installing the LAN cable
 Setting the instrument IP address
 Installing and configuring SDA for 21 CFR Part 11 compliance
 Installing and configuring SCM for 21 CFR Part 11 compliance
 Completing a dark current scan and wavelength calibration

Agilent Technologies 5110 ICP-OES Specifications

General

Brand	Agilent Technologies
Model	5110 ICP-OES
Category	Laboratory Equipment
Language	English