Agilent Technologies 54810A User Manual

Setting Up the Oscilloscope
To attach the optional trackball
1-16
5 Connect the 9-pin “D” connector on the trackball cable to the COM1
port on the back panel. Tighten the retaining screws.
Figure 1-9
Connecting the Trackball Cable to the COM1 Port
For information on changing the trackball settings, see “To change the mouse
settings” in Chapter 3.

Agilent Technologies 54810A Specifications

General

Brand	Agilent Technologies
Model	54810A
Category	Test Equipment
Language	English