10 5977B Series MSD Operating Manual
To Perform a PCI Autotune (Methane Only) 135
To Perform an NCI Autotune (Methane Reagent Gas) 137
To Verify PCI Performance 139
To Verify NCI Performance 140
To Monitor CI Mode High Vacuum Pressure 141
6 General Maintenance
Before Starting 144
Maintaining the Vacuum System 149
Maintaining the Analyzer 150
To Open the Analyzer Chamber 152
To Remove the EI HES 154
To Connect/Disconnect Wiring to the EI HES 156
To Disassemble the EI HES 157
To Clean the EI HES 160
To Assemble the EI HES 163
To Remove the EI HES filaments 168
To Install the EI HES Filament 170
To Install the EI HES 171
To Remove the EI XTR, SS, or Inert Source 172
To Connect/Disconnect Wiring from the EI XTR, SS, and Inert
Sources 173
To Disassemble the EI SS or EI Inert Source 174
To Disassemble the EI XTR Source 177
To Clean an EI XTR, SS, or Inert Source 180
To Assemble an EI SS or Inert Source 185
To Next Page
Loading...
Need help?
General
