5975/5977 Series MSD Operation Manual 3
About This Manual
This manual contains information for operating and
maintaining the Agilent 5975 through 5977 series of MSD with
OpenLAB CDS software. Agilent OpenLAB CDS is a new
operating system for Agilent instruments.
The Agilent 5977B Series Mass Selective Detector (MSD) is the
base instrument described in this manual. Agilent instruments
manufactured prior to the 5977B share many features and
hardware with this new instrument. Where older Agilent
models differ from the 5977B, that difference is usually noted.
Please refer to the operating and maintenance documentation
that was delivered with your instrument if other hardware
differences are found.
1 “Introduction”
Chapter 1 describes general information about the 5977B Series
MSDs, including a hardware description, general safety
warnings, and hydrogen safety information.
2 “Installing GC Columns”
Chapter 2 shows you how to prepare a capillary column for use
with the MSD, install it in the GC oven, and connect it to the
MSD using the GC/MSD interface.
3 “Operating in Electron Ionization (EI) Mode”
Chapter 3 describes basic tasks such as setting temperatures,
monitoring pressures, tuning, venting, and pumpdown. Much of
the information in this chapter also applies to CI operation.
4 “General Maintenance”
Chapter 4 describes maintenance procedures common to both
EI and CI instruments.
To Next Page
Loading...
