Need help?Do you have a question about the Agilent Technologies Cary 50 and is the answer not in the manual?
General| Wavelength Range | 190 - 1100 nm |
|---|---|
| Scan Speed | Up to 2400 nm/min |
| Light Source | Pulsed Xenon Flash Lamp |
| Type | UV-Vis Spectrophotometer |
| Photometric Accuracy | ±0.003 Abs (0-0.5 Abs) |
| Stray Light (at 220 nm, NaI) | <0.0001% |
| Detector Type | Silicon Diode |
| Sample Compartment | Standard cell holder |
| Interface | RS-232 |
| Power Requirements | 100-240 VAC, 50-60 Hz |
| Software | Cary WinUV |
| Data Acquisition | Yes |
| Photometric Range | -4 to 4 Abs |
| Photometric Range (Abs) | -4 to 4 Abs |
Defines CAUTION notices, indicating hazards that could damage equipment or data if not followed.
Defines WARNING notices, indicating hazards that could cause personal injury or death if not followed.
Information on the lamp module, its high voltages, and eye safety precautions when operating.
Details on electrical safety, emphasizing computer power supply integrity and compliance with IEC 60950.
Explains the format and meaning of WARNING and CAUTION messages to ensure safe operation.
Illustrates and explains hazard symbols used in the manual and on the instrument for various risks.
Detailed steps for replacing the lamp module, including safety precautions and disconnection.
Procedure to align the source mirror after lamp replacement using adjustment screws for optimal performance.
Resolves issues where Windows XP reports service or driver failure during startup using Event Viewer.
To Next Page
