46 5975/5977 Series MSD Operation Manual
3 Operating in Electron Ionization (EI) Mode
Operating the MSD from the Data System
The Agilent OpenLAB CDS software automates tasks such as pumping down,
monitoring settings, setting temperatures, tuning, and venting the MSD. These
tasks are described in this chapter. Additional information is described in the
manuals and online help supplied with the OpenLAB CDS software.
CAUTION
The software and firmware are revised periodically. If the steps in these procedures do
not match your OpenLAB CDS, refer to the manuals and online help supplied with the
software for more information.
To Next Page
Loading...
