Getting Started
Step 4. Set up and run an acquisition method
Agilent 6400 Series Triple Quadrupole LC/MS Quick Start Guide 21
3 Enter the Triple Quadrupole parameter values.
a Select the Scan Type from the list in the Time segments table. The Scan
segments table is cleared when you change the Scan Type. The parameters
available on the right change depending on the Scan Type.
If you are changing the Scan Type from MRM to Dynamic MRM or to
Triggered MRM, you can copy and paste the transitions from the original
Scan segments table to the Clipboard and then to the new Scan
segments table. See the online Help for more information.
b Type in any Acquisition values you want to change. You can enter multiple
Scan segments.
You cannot set the fragmentor voltage in Acquisition if the instrument type is
an Agilent 6490 or an Agilent 6495. It always uses the value in the tune file.
4 Set up to change Triple Quad MS parameters with segments and scans:
a To add a segment, right-click anywhere in the Scan segments section to
bring up the Scan Segments shortcut menu, and click Add Row.
b Type the parameters for each Scan segment.
To Next Page
Loading...
Need help?
General
