Quick Reference 15
[Oven] Sets oven temperatures, both isothermal and
temperature programmed.
[Front Inlet]
[Back Inlet]
Controls inlet operating parameters.
[Col 1]
[Col 2]
[Aux Col #]
Controls column pressure, flow, or velocity.
Can set pressure or flow ramps.
[Front Det]
[Back Det]
[Aux Det #]
Controls detector operating parameters.
[Analog Out 1]
[Analog Out 2]
Assigns a signal to the analog output. The
analog output is located on the back of the
GC.
[Front Injector]
[Back Injector]
Edits injector control parameters such as
injection volumes and sample and solvent
washes.
[Valve #] Allows for configuration or control of the gas
sampling valve (GSV) and/or switching valves
1 to 8 on or off. Sets multiposition valve posi-
tion.
[Aux Temp #] Controls extra temperature zones such as a
heated valve box, a mass selective detector,
an atomic emission detector transfer line, or
an “unknown” device. Can be used for tem-
perature programming.
[Aux EPC #] Provides auxiliary pneumatics to an inlet,
detector, or other device. Can be used for
pressure programming.
[Column Comp] Creates a column compensation profile.
To Next Page
Loading...
Need help?
General
