Need help?Do you have a question about the Agilent Technologies 7673 and is the answer not in the manual?
General| Brand | Agilent Technologies |
|---|---|
| Model | 7673 |
| Category | Laboratory Equipment |
| Language | English |
Describes the three main modules of the automatic liquid sampler.
Details environmental, space, and electrical requirements for sampler installation.
Instructions for mounting and connecting the injector module to the system.
Steps for physically installing the tray module onto the injector bracket.
Guidance on connecting the controller module and its power cord.
Explains how to select, label, fill, cap, and place sample vials.
Instructions on how to turn the injector fan on or off.
Guidance on selecting, filling, and placing solvent and waste bottles.
Details on choosing and properly installing the correct syringe.
Information on changing septa and cleaning inlet liners.
Steps to configure the sampler for cool on-column injection.
Explains how to configure parameters that control sampler operation.
Describes the sequence of actions the sampler performs during a run.
A list of items to verify before starting sampler operation.
Instructions for starting and stopping sample runs or sequences.
Details on operating the sampler with two injectors.
Overview of different controlling devices for the automatic liquid sampler.
Illustrative examples of setting up the sampler for different configurations.
How to set operational parameters using the injector's control switches.
Procedures for starting and stopping runs in standalone mode.
Operating two injectors independently in standalone mode.
Practical example of configuring the sampler for standalone operation.
Suggestions for ensuring good performance through regular maintenance.
Instructions for removing and installing the turret assembly.
Steps to perform after changing the turret to ensure correct alignment.
Guide to identifying and resolving common problems based on symptoms.
To Next Page