Setting Up
Installing the injectors
7
WARNING Any interruption of the grounding conductor or disconnection of the power
cord could cause a shock that results in personal injury.
Connecting the controller power cord
1. Check the on/off button on the front of the controller. It must be off or
flush with the front panel before you plug in the power cord. The symbol
“ ” indicates standby. The symbol “|” indicates on.
2. Plug the female end of the power cord into the AC power receptacle on the
back of the controller.
3. Plug the male end of the power cord into the AC power receptacle of your
facility.
Installing the injectors
The injector contains the syringe, a syringe carriage, a six-position standard
turret, a cooling fan that you can turn off, parameter switches, and a last
sample vial switch.
The turret rotates sample vials and solvent and waste bottles into position
under the syringe. Without a tray, you load the sample vials manually into the
turret (maximum of three samples). With a tray, the robotic arm loads the vials
(up to 100 samples). You load the solvent and wash bottles manually (the
quantities of each depend on your controlling device). For more information on
the fan, see “Using the injector fan” on page 34.
To Next Page
Loading...
Need help?
General
