Setting Up
Installing the controller
18
This section covers connecting the injector and tray cables to the controller,
connecting the controller to the GC, connecting the controller to the data
handling device, and plugging in the controller.
Find the power cord in the controller box. Check the shape of the plug and the
source voltage listed on the packing contents sheet. Verify that the power cord
is appropriate for the power source at your facility.
Connecting cables to other instruments
The automatic liquid sampler communicates to other instruments via cables
that connect to the various connectors on the controller. Figure 13 shows the
connectors on the back of the controller and what they are used for.
Figure 13. Common cable connections
Connect to the
bar code reader
Connect to a
computer
Connect to the
Instrument
Network
Connect to the injector modules
Connect to the tray module
RS-232-C to computer
To Next Page
Loading...
Need help?
General
