Operation
6890 Series GC Control
79
When in the sequence control table, you will find the [Info] key useful if an
explanation of sequence parameters is needed.
Storing a sequence
Up to five sequences can be stored.
1. To store a sequence, press [Store][Seq]. This opens the Store Sequence
control table.
2. Enter an identifying number for the sequence.
3. Press [Enter] to store the sequence.
If the sequence number you specified already exists, you will be prompted to
either:
• Overwrite the existing sequence, which will replace the existing sequence
with the new sequence.
To Next Page
Loading...
Need help?
General
