26
Preparing for Operation
This chapter contains detailed information for preparing the automatic liquid
sampler for operation, including:
• Preparing sample vials
• Using the injector fan
• Preparing the solvent and waste bottles
• Selecting and installing syringes
• Maintaining the inlet
• Adapting for cool on-column injection
To optimize your sampler operation, it is important to have thorough
preparation of your samples, sample vials, syringes, and inlets. Regular
maintenance also keeps your equipment and analysis running smoothly. For
more information, see chapter 5, “Preventive Maintenance and
Troubleshooting.”
Preparing sample vials
This section explains how to select, label, fill, cap, and place the sample vials.
Selecting and labeling sample vials
The injector and the tray use glass sample vials and crimp caps or Target
®
DP
™
screw-cap vials that meet a set of specifications. These are available with a
write-on spot for easy labeling. If you choose to make your own labels, read the
following specifications for location and thickness of labels.
To Next Page
Loading...
Need help?
General
