Quick Reference 23
Keypad Functionality When the GC Is Controlled
by an Agilent Data System
When an Agilent data system controls the GC, the data
system defines the setpoints and runs the samples. If
configured to lock the keypad, the data system can
prevent the changing of setpoints. The Remote LED is
lit when a data system is controlling the GC. Lit LEDs on
the status board show the current progress of a run.
When controlled by a data system, the keypad can be
used:
• To view run status by selecting [Status]
• To view the method settings by selecting the GC com-
ponent key
• To display the last and next run times, the run time
remaining, and the post-run time remaining by
repeatedly selecting [Time]
• To abort a run by selecting [Stop]
To Next Page
Loading...
