Quick Reference 17
[Mode/
Typ e ]
Accesses a list of possible parameters associated
with a component’s nonnumeric settings. For
example, if the GC is configured with a split/split-
less inlet and the [Mode/Type] key is pressed, the
options listed will be split, splitless, pulsed split, or
pulsed splitless.
[Clear] Removes a misentered setpoint before pressing
[Enter]. It can also be used to return to the top line
of a multiline display, return to a previous display,
cancel a function during a sequence or method, or
cancel loading or storing sequences and methods.
[Enter] Accepts changes you enter or selects an alternate
mode.
Scrolls up and down through the display one line at
a time. The < in the display indicates the active
line.
Numeric
Keys
Enters settings for the method parameters (Press
[Enter] when you are finished to accept the
changes.)
[On/Yes]
[Off/No]
Sets parameters, such as the warning beep,
method modification beep, and key click or for turn-
ing on or off a device like a detector.
[Front]
[Back]
Identifies configuration settings. For example,
when configuring a column, use these keys to iden-
tify the inlet and detector to which the column is
attached.
[Delete] Removes methods, sequences, run table entries,
and clock table entries. [Delete] also aborts the
adjust offset process for nitrogen-phosphorus
detectors (NPD) without interrupting other detec-
tor parameters. See the Agilent 7890A GC
Advanced User Guide for more details.
To Next Page
Loading...
