Agilent Technologies E3634A - Constant Voltage Operation

Chapter 2 Quick Start
To Program Overvoltage Protection
36
3 Clear the overvoltage condition and exit this menu.
Now, when you press key again, the “DONE” message is displayed for a
se co nd and the
OVP annunciator will not blink any more. The output will return
to meter mode.
• Adjust OVP trip level
1 Raise the OVP trip level.
Press key and turn the knob to raise the OVP trip level.
2 Move to the OVP CLEAR mode.
Press key to move to the OVP CLEAR mode. The “OVP ON” message
appears on the display. Turn the knob to the right until the above message
appears on the display.
3 Clear the overvoltage condition and exit this menu.
Now, when you press key again, the “DONE’’ message is displayed for
a second and the
OVP annunciator will not blink any more. The output will
return to the meter mode.
OVP
OVPOVP
OVP CLEAR
Over
Voltage
Over
Voltage
Over
Voltage
Over
Voltage
Over
Voltage
Over
Voltage
Over
Voltage
Over
Voltage