Chapter 4 Remote Interface Reference
RS-232 Interface Commands
89
4
RS-232 Interface Commands
Use the front-panel ‘‘I/O Config’’ key to select the baud rate, parity, and the
number of data bits (see chapter 3 ‘‘Remote Interface Configuration’’,
starting on
page 46).
SYSTem:LOCal
This command places the power supply in the local mode during RS-232
operation. Al l keys on the front panel are full y functional.
SYSTem:REMote
This command places the power supply in the remote mode for RS-232
operation. Al l keys on the front panel, except the ‘‘
Local
’’ key, are disabled.
SYSTem:RWLock
This command places the power supply in the remote mode for RS-232
operation. This command is the same as the
SYST:REM
command except that
all keys on the front panel are disabled, inclu ding the ‘‘
Local
’’ key.
Ctrl-C
This command clears the operation in progress over the RS-232 interface and
discards any pending output data.
This is equivalent to the IEEE -488 device
clear action over the GPIB interface.
It is very imp ortant that you send the
SYST:REM
com mand to place the
pow er supp ly in the rem ote m ode. Sen ding or re ce iving data over the
RS-232 interface when not configured for remote operation can cause
unpr ed ictabl e re su lts .
To Next Page
Loading...
Need help?
General
