68
Remote Interface Reference
• SCPI Command Summary‚ starting on page 69
• Simplified Programming Overview‚ starting on page 74
• Using the
APPLy
Command‚ on page 77
• Output Setting and Operation Commands‚ starting on page 78
• Triggering‚ starting on page 82
• System-Related Commands‚ starting on page 85
• State Storage Commands‚ on page 88
• Calibration Commands‚ starting on page 89
• Interface Configuration Commands‚ on page 92
• The SCPI Status Registers‚ starting on page 93
• Status Reporting Commands‚ starting on page 101
• An Introduction to the SCPI Language‚ starting on page 103
• Halting an Output in Progress‚ on page 108
• SCPI Conformance Information‚ starting on page 109
• IEEE-488 Conformance Information‚ on page 112
If you are a first-time user of the SCPI language, you may want to refer to
these sections to become familiar with the language before attempting to
program the power supply.
SCPI
SCPI
SCPI
To Next Page