Hardkey and Softkey Reference ESG Family Signal Generators
Sweep/List
4-98 User’s Guide
Configure Step Sweep
Pressing this softkey reveals a menu of softkeys for defining a step
sweep. In this menu you can set the start and stop frequencies for a
sweep, set the start and stop power levels, and you can set the number
of points in the sweep with the dwell time at each point.
Softkey Location:
Sweep/List > Configure Step Sweep
Delete File
Press this softkey to delete a file in the catalog listing. Use the up and
down arrow keys until the file you wish to delete is highlighted. Press
Delete File and then press the Confirm Delete softkey. Be certain that you
want to delete the file; you cannot recover this sweep data once you
press
Confirm Delete. If you do not want to delete the file, press Return
instead of
Confirm Delete.
Softkey Location:
Sweep/List > Configure List Sweep > Load/Store > Delete File
Delete Item
Press this softkey to delete an item in the displayed list of sweep points.
Use the arrow keys until the desired item is highlighted. Then press
Delete Item to eliminate this item from the sweep list. Be certain that you
want to delete this item; you cannot recover it once you have deleted it.
If the last item in a list is deleted, it is replaced by the default value.
Softkey Location:
Sweep/List > Configure List Sweep > Delete Item
Delete Row
Press this softkey to delete a selected row in the sweep list. Use the up
and down arrow keys until any item is selected in the row you wish to
delete. Press
Delete Row and the entire row is deleted. Be certain that
you want to delete the row; you cannot recover this sweep data once you
press
Delete Row. If the last row in a list is deleted, it is replaced by the
default value.
Softkey Location:
Sweep/List > Configure List Sweep > Delete Row
To Next Page
Loading...
Need help?
General
