Chapter 4
Front-Panel Key and SCPI Command Reference
Measure
158
Front-Panel Key and SCPI Command
Reference
4.3.3 RF Power
Allows the user to switch to the RF Power measurement.
4.3.3.1 SCPI Remote Commands
:CONFigure:RFPower
:INITiate:RFPower
:FETCh:RFPower[n]?
:MEASure:RFPower[n]?
:READ:RFPower[n]?
Mode: MRECEIVE
Key Path:
Measure
Remote Command: :CONFigure:RFPower
Notes: This key invokes RF Power Measurement.
Example: :CONF:RFP
Index: n
<Mnemonic>
Results Returned
not specified or
n = 1
Returns the following 4 values:
RF Power (dBm, Watt or Volt depending on the Display Unit setting)
RF Power
Reference RF Power (–999 in Normal mode, depends on Display Mode setting)
Relative RF Power (–999 in Normal mode, dB/%, depends on Ratio Mode setting)
RF Frequency (Hz)
Cal Factor (%, the Cal Factor is the value queried from the Cal Factor table according to the Carrier
Frequency)
To Next Page
Loading...
Need help?
General
