80 Chapter 3
Making Measurements
Tuned RF Level Measurement
Troubleshooting Hints
The following red status indicators may appear in the measurement result window,
or the following error messages on the bottom of the screen:
• PMError -- No Power Meter connected or you need to perform the Power
Meter Calibration.
• Uncal -- You need to perform the Power Meter Calibration.
• Recal -- You need to perform the Range Calibration manually. Press
Meas
Setup
, TRFL Calibrate.
• NotReady -- No data is captured by the Power Meter. The power level at the
sensor module input may be too low.
• Ready -- The Power Meter has captured the data.
• Remain: xxx.xx sec -- Tells you how long to get the next stable result.
For more information, press
System, Show Errors.
To Next Page
Loading...
Need help?
General
