Chapter 4
Front-Panel Key and SCPI Command Reference
Measurement keys
214
Front-Panel Key and SCPI Command
Reference
4.4.5.2.2 FM Deviation Waveform Window
If the Waveform Window is chosen, the following menu is available.
4.4.5.2.2.1 Scale/Div
Allows you to enter a numeric value to change the vertical display sensitivity.
4.4.5.2.2.2 Ref Position
Allows you to set the display reference position to either Top, Ctr (center), or Bot (Bottom).
Mode: MRECEIVE
Key Path:
Amplitude Y Scale
Remote Command: :DISPlay:FMDeviation[1]|2:WINDow[1]|2|3|4:TRACe:Y[:SCALe]:
PDIVision <freq>
:DISPlay:FMDeviation[1]|2:WINDow[1]|2|3|4:TRACe:Y[:SCALe]:
PDIVision?
Unit: Hz
Preset: 1000
State Saved: Saved in instrument state.
Range: 1 Hz to 1 GHz
Dependencies/Couplings: See Restriction and Notes
Notes: If the Scale Coupling is set to On, this value is automatically determined by the
measurement result. When you set this value manually, Scale Coupling
automatically changes to Off.
Example: :DISP:FMD2:WIND:TRAC:Y:PDIV 20
:DISP:FMD2:WIND:TRAC:Y:PDIV?
Mode: MRECEIVE
Key Path:
Amplitude Y Scale
Remote Command: :DISPlay:FMDeviation[1]|2:WINDow[1]|2|3|4:TRACe:Y[:SCALe]:RPOSition
TOP|CENTer|BOTTom
:DISPlay:FMDeviation[1]|2:WINDow[1]|2|3|4:TRACe:Y[:SCALe]:RPOSition
?
Preset: CENTer
State Saved: Saved in instrument state.
Range: Top | Ctr | Bottom
Example: :DISP:FMD:WIND:TRAC:Y:RPOS TOP
:DISP:FMD:WIND:TRAC:Y:RPOS?
To Next Page
Loading...
Need help?
General
