Chapter 1 11
Installation and Setup
Power Requirements
AC Power Cord
The analyzer is equipped with a three-wire power cord, in accordance with international safety
standards. This cable grounds the analyzer cabinet when connected to an appropriate power line outlet.
The cable appropriate to the original shipping location is included with the analyzer.
Various AC power cables are available that are unique to specific geographic areas. You can order
additional AC power cables for use in different areas. AC Power Cords, on page 12 lists the available AC
power cables, illustrates the plug configurations, and identifies the geographic area in which each cable
is appropriate.
NOTE The front panel switch is a standby switch only; it is not a LINE switch (power
disconnecting device).
WARNING Install the product so that the detachable power cord is readily identifiable and
easily reached by the operator. The detachable power cord is the product
disconnecting device. It disconnects the mains circuits from the mains supply before
other parts of the product. The front panel switch is only a standby switch and is not
a LINE switch. Alternatively, an externally installed switch or circuit breaker
(which is readily identifiable and is easily reached by the operator) may be used as a
disconnecting device.
CAUTION Always use the three-prong AC power cord supplied with this product. Failure to ensure
adequate earth grounding by not using this cord can cause product damage.
CAUTION This analyzer has autoranging line voltage input. Be sure the supply voltage is within the
specified range. (Refer to the specifications guide for your analyzer.)
To Next Page
Loading...
Need help?
General
