44 Chapter 1
Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
The preset condition is to have all bits in this enable register set to 0. To have any
Operation Events reported to the Status Byte Register, one or more bits need to be set to 1.
R&D: There is little reason to have any bits enabled for typical manufacturing tests.
Enabling bits in this register would be of more value during test development.
Operation Event Query This query returns the decimal value of the sum of the bits in the
Operation Event register.
The register requires that the associated PTR or NTR filters be set before a condition
register bit can set a bit in the event register. The data in this register is latched until it is
queried. Once queried, the register is cleared.
Operation Negative Transition This command determines which bits in the Operation
Condition register will set the corresponding bit in the Operation Event register when the
condition register bit has a negative transition (1 to 0). The variable <integer> is the sum
of the decimal values of the bits that you want to enable.
Mode All
Remote Command :STATus:OPERation:ENABle <integer>
:STATus:OPERation:ENABle?
Example STAT:OPER:ENAB 1 Sets the register so that Align Now
operation is reported to the Status Byte Register.
Preset 0
Min 0
Max 32767
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:OPERation[:EVENt]?
Example STAT:OPER?
Preset 0
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:OPERation:NTRansition <integer>
:STATus:OPERation:NTRansition?
Example STAT:OPER:NTR 1 Align Now operation complete is reported
to the Status Byte Register.
To Next Page
Loading...
Need help?
General
