Agilent Technologies Varian CP-8410 User Manual

Installing the CP-8400/8410
CP-8400 AutoSampler & CP-8410 AutoInjector 7
Carrousel Removed to Show Mounting Screw Locations
8. Plug the D-shell connector of the power/communications cable
into the CP-8400/8410.
9. Remove protective shipping materials from the injector carriage
and install the syringe into the AutoSampler injector tower by
opening the clear plastic door, carefully inserting the syringe into
its holder and the needle through its guide, then fasten the
plunger screw on the top and snap the retaining clip over the
syringe.
Screw Holes: Used
in mounting both
front and rear
A
utoSampler
positions.
Screw hole used in
mounting rear position
only.
Screw hole used in
mounting front position
only.

Agilent Technologies Varian CP-8410 Specifications

General

Brand	Agilent Technologies
Model	Varian CP-8410
Category	Laboratory Equipment
Language	English