AGM 520 E - User Manual

117 pages

Go to English

Save Page as PDF

To Next Page

AGM

520 E (SI)

BENCINSKA KOSA

AGM 520 E

Originalna navodila za uporabo

Questions and Answers

A
Austin ReedSep 10, 2025
What to do if my AGM Trimmer has poor output power?
- E
  Emily CoxSep 12, 2025
  If your AGM Trimmer is producing poor output power, several factors could be responsible: * A clogged fuel filter or fuel lines can restrict fuel flow. Clean the fuel filter and fuel lines. * Insufficient fuel can also cause this issue. Clean the fuel filter and fuel lines. * Oil deposits in the exhaust pipe or combustion chamber can hinder performance. Clean the oil deposits. * Worn piston, piston ring, or cylinder can reduce efficiency. Replace the piston and piston ring. * Leakage at the joint of the cylinder and the carter can affect power. Repair the leakage. * Poor sealing can lead to power loss. Replace the seal.
N
Nicole DavisNov 3, 2025
Why won't my AGM 520 E Trimmer engine start?
- S
  Stephen RobinsonNov 3, 2025
  If your AGM Trimmer's engine won't start, there could be several reasons: * The fuel tank may be empty, in which case you should add fuel. * The fuel filter might be clogged, requiring cleaning. * The fuel could be too dirty or contain water, necessitating a replacement. * There might be too much fuel in the cylinder; remove the spark plug and dry it. * The fuel mixture ratio could be incorrect; create the proper mixture. * The spark plug might be dirty with oil deposits; clean them off. * The spark plug insulation could be damaged; replace the spark plug. * The spark plug clearance may be incorrect; set it to 0.6-0.7mm. * The high-voltage spark plug cable might be cracked or broken; replace or tighten it. * The coil could be loose; tighten it. * The piston ring migh...