keep the remote control in your hand so that you can control the drone at any time.
③ Flying within line of sight: Please keep the drone always within line of sight and
avoid flying behind tall obstacles that may block the line of sight.
④ Control flight altitude: In order to ensure the flight safety of drone and civil aviation,
please control the height of drone within 30 meters. If there is a no-fly or flying altitude
restriction below 30 meters in your area, please follow the regulations.
(2) Flight environment requirements
①Do not spray in a windy environment, such as wind speed above 5m/s.
② Do not fly in bad weather, such as strong wind (8m/s and above), heavy rain
(12-hour rainfall of 25 mm and above), snow, foggy weather, etc.
③ AGR APP will automatically identify the weight of the fertilizer, and the drone
greater than the rated load weight will be restricted from unlocking.
④ Ensure that the GNSS signal is good during operation and the RTK antenna is not
blocked.
(3) Return home function
The drone automatically flies back to the home-point in the following cases:
①If the amount of pesticide/fertilizer is empty, the behavior is set to return home, and
the drone will automatically return home when the pesticide/fertilizer is cut off.
② After the completion of the route operation, the behavior is set to return home, and
the drone will automatically return home after performing the route operation.
③ When performing the operation, the user clicks to return home through AGR APP,
and the drone will automatically return home.
④ The behavior of the remote control is set to return home, and the drone will
automatically return home after the remote control and the drone are disconnected during
flight.
The user sets the remote control loss behavior in the AGR APP: return home or
hover. The runaway return home function will only take effect when it is set to return home.
The factory default runaway protection behavior is hover.
(4) Precautions for pesticide use
① Avoid the use of powder pesticides, otherwise it will affect the service life of the
spraying system.
② Scientific use of pesticides, strictly in accordance with the safety specifications for
pesticide use.
③ When dispensing, please use water, after the dispensing is completed, it needs to
be filtered and then added to the pesticide tank to avoid impurities blocking the filter
screen.
④ The effect of pesticides is related to factors such as temperature, humidity and
wind in the working environment, and the appeal factors should be comprehensively
considered when using drugs to achieve the best effect.
⑤Ensure that the pesticide will not cause harm or impact to the surrounding people,
animals and the environment.
To Next Page
Loading...
