Step 9: Spray calibration
Add 35L clean water into the spray Tank, click to spray calibration, the system will record
the maximum flow rate of the pump
When the flow rate is too low, check whether the filter is blocked
6.Checking before Taking off
(1) User faces the tail of drone. People are more than 10meters
away from the drone to keep at a safe distance.
(2) Check the Remote Control Joystick Mode.
Enter the APP execution interface and check whether the remote control joystick mode
on the parameter information bar is correct (abbreviation: US-American hand, CN-Chinese
hand, JP-Japanese hand). To change the joystick mode, go to More Settings → Remote
Control Settings → Modify Joystick mode.
The factory default setting is the US hand, and the following introduction and
illustration are based on the US hand.
The joystick mode must be familiar to the user, otherwise flight safety accidents may
occur.
(3) Check the status
Drone can be unlocked only after confirming that the parameters of the APP execution
interface are normal; Check whether there is an abnormal alarm prompt in the status bar,
and confirm that the device information status bar is green before you can take off safely.
To Next Page
Loading...
