36 agria Grassland Mower 5100
5. Maintenance
5
5
Safety circuit
Check the safety circuit function each time you
maintain or service the machine.
l
Upon release of the handle (B/1) and with
clutch engaged the engine must come to a stop.
l
Check the electric lines and connections for
good condition, replace, if necessary.
è - Serviceç
General
l
Before you take up operation watch out for
fuel and oil leakage and repair, if necessary.
l
Regularly check bolts and nuts for tight fit
and retighten, if necessary.
l
Slightly grease all gliding and moving parts
(e.g. speed control lever, hand lever bearing,
etc.) with Bio-lubricating grease and Bio-
slushing oil (refer to “Lubrication Chart”, page
42).
Cleaning
After each cleaning (washing with water, es-
pecially with pressure washer) lubricate all lu-
brication points, oil and let the mower run for a
short time to press water out.
Apply grease generously to leave a grease ring
around bearings to prevent water, plant sap,
and dirt from penetrating.
Clean the engine only with a cloth. Avoid
spraying with air-compressed water jets, as
water might leak into ignition and fuel system,
causing malfunctions.
To Next Page
