18
4.3) Micrometrically
adjustable strap retention
system
The micrometrically adjustable
strap retention system needs the
strap to be adjusted for length
before being fastened.
The following instructions and
diagrams show you how to
adjust the length of the strap by
increasing or decreasing the
amount which passes through
the ring (1) until the helmet ts
perfectly with the strap fastened.
To fasten the helmet, insert the
pronged section into the buckle
(2) and press it rmly home (3)
until you feel the strap pressing
against your jaw. The micrometric
adjustment system allows even
N.B. THE PRESS STUDS/VELCRO ON THE RETENTION SYSTEM ARE NOT FOR
FASTENING THE HELMET BUT ONLY TO PREVENT FLAPPING: THEY MUST NOT BE
USED AS AN ALTERNATIVE FOR FASTENING THE STRAP.
more precise “calibration” of the strap for improved comfort thanks to the
number of settings available (We recommend however that you insert the
strap as far into the buckle as possible).
Make sure that the helmet ts your head perfectly (also see “Choosing the
right helmet” in the “Safety Warning” booklet).
To unfasten the helmet, lift the red lever with the help of the fabric tape (4)
then slide the strap out of the buckle (5).
1
2
3
4
5
To Next Page
Loading...
Need help?
General
