Ahlborn ALMEMO 710 - 6. Putting into service

6. Putting into service
6. PUTTING INTO SERVICE
Sensor connection Connect sensors to sockets M0 to M9 (1). see 8
Power supply Via rechargeable battery or charge adapter
connected at socket DC (3) see 7.1, 7.2
To switch ON Press and hold down touchkey ON-OFF (6) . see 7.5
Automatic display of last measuring menu see 11
To select data logger menu using tab:
Once-only output see 10.4 Manual
Cyclic measuring Enter save-to-memory cycle:
Output cycle (hh:mm:ss) with saving see 9.7
or scan cycle (hh:mm:ss.sss) with saving
To start cyclic measuring Start see 10.4
To select measured value display
1. To select channels list see 9.2
Display of max. / min. values in channels list
To delete touch on appropriate max. / min. field.
For single display select the required channel
from list, e.g.
2. To select bar chart
3. To select line graph
4. To select user menu
To stop measuring Stop
To output from memory to printer or to computer
Memory output via interface
- Connect peripheral equipment via data cable to socket A1 (2) (see Man. 5.2)
- On the peripheral device set 9600 baud, 8 data bits, 1 stop bit, no parity.
To select data logger menu
To select memory output see 10.6
To start output Start output
To delete memory content Delete memory
16 ALMEMO
®
710