Measuring by means of a measuring channel
Averaging in progress
Output function active: Diff, Hi, Lo, M(t), Alarm (s. 13.2.5.1)
Temp. compensation CT active: Value, fixed, measured
Atm. pressure compensation
CP
active; Value, fixed, measured
Below the measured value the functions - range, maximum and minimum val-
ues (s. XREF) - are still available; and these can also be used. Below the
measured value, if it is compensated in terms of some other value, the com -
pensation values in question also appear.
By means of the ´Channel parameters´ tab all the parameters for the
channel in question can be viewed over 4 pages and directly modified.
The following table lists the functions and section references:
13.2.1 Channel designation
13.2.2 Measured value smoothing
13.2.4 Averaging mode
10.1.3.1 Cycle factor
13.2.13.7 Minimum sensor supply voltage
13.2.6 Locking level
13.2.7 Limit values, maximum and minimum
13.2.8 Actions, maximum and minimum
13.2.8 Relays, maximum and minimum
13.2.9 Analog output start / end
13.2.11 Base value, factor, decimal point shift
13.2.10 Zero-point and gain
13.2.12 Units
13.2.5.1 Output function
13.2.13 Measuring range with reference channel and multiplexer
13.2.10 Calibration offset and calibration factor
Alternatively, the individual ´Channel functions´ (see 13.2) can also be found
bottom right via the ´Channel functions´ option and the appropriate heading..
12.2 Measured value correction and compensation
To achieve maximum measuring accuracy the zero-point of the sensors can
be corrected in all menus at the touch of a button. By entering a setpoint the
correction value will be automatically calculated and stored in the sensor con-
nector. For sensors affected by ambient temperature or atmospheric pressure
the appropriate compensation can then be provided.
ALMEMO
®
710 41
To Next Page
Loading...
