Averaging
Set averaging over a cycle Averaging mode CYCL
Program the output cycle (see 10.1.3) Output cycle 00:15:00
Start measuring operation, averaging in progress START
Stop the measuring operation STOP
Read out average value / cycle in the function Average value 13.24 m/s
Averaging over manually set periods of time
Using the same averaging mode but without the cycle the average value can
also be obtained over the period of time from one manual measuring channel
scan to the next.
Set averaging over a cycle Averaging mode CYCL
Select the cycle and delete by pressing Clr
Cycle timer 00:00:00
Start measuring operation, averaging in progress START
Manual measuring channel scan Manual
Average value over time from one measuring channel scan to the next Average value 12.34 ms
For recording average values an additional
function channel
with the
quantity M(t) or the corresponding
output function
M(t) is required -
instead of the measured value. (see 13.2.5.1, Manual 6.10.4).
14.4.4 Averaging over measuring channels
In all measuring channel scans the average value can also be determined over
a number of associated measuring channels. However, for this average value
a function channel with the measuring range M(n) must be available. (see
13.2.13) If you do not wish to program reference channels and the measuring
channels to be averaged begin with M0.0, you need simply to program the
function channel M(n) to the 2nd channel of the last connector (e.g. M3.1).
(see 13.2.13.1) This will then refer automatically to the series from reference
channel 2 (M0.0) through to reference channel 1 (M3.0 = 1st channel). Other
measuring channel ranges can be activated by programming the reference
channels accordingly. (see 13.2.13.4).
Via ´Select channel´ select average value for meas. channel 0.0
In the next line enter up to measuring channel 4.0
Freely selectable channel for the function channel ´Average value´ M(n) 4.1
Here the average value M(n) appears e.g. average value 10.78 m/s
ALMEMO
®
710 71
To Next Page
Loading...
