Function keys
9.3 Function keys
For the purpose of controlling measuring operations there are just a few super-
ordinate keys located along the bottom edge of the screen.
To start a cyclic measuring operation see 10.4
To stop a cyclic measuring operation
Once-only
manual
output / saving of all measured values
Call up
settings
for local menu
key
in the menu
If applications occupy more than one page, the arrow keys
can be used to access the current page.
9.4 Status LEDs
The status LEDs (5) report the current device status as follows :
ON Device is switched ON.
SLEEP flashes briefly just once Device is in sleep mode.
CHARGE
Device's batteries are being recharged.
START is lit continuously Cyclic measuring has started.
lights up briefly Once-only measuring channel scan
REC is lit continuously Cyclic measuring channel scan with data saving
This also lights up during output from memory.
flashes Data saving at scan cycle
lights up briefly Once-only measuring channel scan with data saving
COM is lit continuously Cyclic measured value transmission to PC
flashes Measured value transmission to PC at scan cycle
lights up briefly
Once-only measuring channel scan transmits data to PC
ALARM Limit value infringement or sensor breakage
ALARM flashes Supply voltage to device too low
LOCKED
Key operation is restricted by block function.
9.5 Status symbols
Battery status and memory status are displayed on the far right of the top
line.
Battery charge status full/normal/almost empty/being recharged
Memory status empty / normal / almost full
By touching on the appropriate symbol the exact status
can be viewed in the associated menu..
ALMEMO
®
710 23
To Next Page
Loading...
