Ahlborn ALMEMO 710 - Page 4

2. Table of contents
10.1.2 Scan cycle with output..............................................................27
10.1.3 Output cycle.............................................................................29
10.1.4 Memory, internal.......................................................................29
10.1.5 Memory connector with memory card.......................................30
10.1.6 Numbering of measuring operations........................................31
10.2 Memory - comments text................................................................31
10.3 Scan mode.......................................................................................31
10.4 Starting and stopping measuring operations...............................33
10.4.1 Start date and time, Stop date and time...................................33
10.4.2 Fixed measuring period............................................................34
10.5 Memory status, delete memory content........................................34
10.6 Memory output................................................................................35
11. MEASURED VALUE DISPLAY.................................................................36
11.1 Channels list....................................................................................36
11.2 Bar chart...........................................................................................36
11.3 Line graph........................................................................................37
11.4 User menus......................................................................................38
11.4.1 Functions..................................................................................38
12. SENSORS.................................................................................................40
12.1 Measuring by means of a measuring channel..............................40
12.2 Measured value correction and compensation............................41
12.2.1 Set measured value to zero......................................................42
12.2.2 Zero-point adjustment..............................................................42
12.2.3 Sensor adjustment for chemical sensors and probes...............42
12.2.4 Two-point adjustment with setpoint entry..................................43
12.2.5 Temperature compensation.....................................................43
12.2.6 Atmospheric pressure compensation.......................................44
12.2.7 Cold junction compensation (CJC)...........................................44
13. SETTINGS................................................................................................ 46
13.1 Sensor settings...............................................................................46
13.2 Channel functions...........................................................................47
13.2.1 Channel designation.................................................................47
13.2.2 Measured value smoothing......................................................48
13.2.3 Maximum / minimum values with date and time-of-day............48
13.2.4 Averaging mode.......................................................................49
13.2.5 Measured value output.............................................................49
13.2.6 Channel locking........................................................................50
13.2.7 Limit values..............................................................................50
13.2.8 Actions triggered by limit value infringement............................51
13.2.9 Analog output...........................................................................51
13.2.10 Correction values...................................................................52
13.2.11 Scaling values........................................................................52
13.2.12 Units.......................................................................................52
4 ALMEMO
®
710