6. Setup of ru
ler
Click the item “Setting-〉Ruler” in Menu or the button “
” in Toolbar, and the setup box
of ru
“Ruler”, W
uler60X” for 1X optical lens and “Ruler180X” for 3X optical lens. If the box in front of
“Hid ould be concealed.
rush colors
n
ler would appear in the right of the interface. Within the ruler setup box, the user could set up
“Measurement Units”, “Measurement Precision” and “ hether to Conceal Descriptors”.
Select “R
e Desc” is ticked, the parameter descriptions w
7. Setup of b
“Click the item “Setting-〉Color” in Menu or the butto
” in Toolbar, the setup box of
brush co
lors would appear in the right of the interface, and in the Color Setup Box, such items like
“Color”, “Selection Status” and “Width” could be set up.
h
tting-
Normal: Color of normal images
Pass: Color of images selected
Width: Width of brus
8. Font setup
Click the item “Se 〉Font” or the button “
” in Toolbar and the font setup box
would appear in the right of the interface. And in the font setup bar, the items like “Font”, “Font
Sizes”, “Color” and “Selection Status” could be set up.
9. Conceal all the current boxes of parameter setup and adjustment
Sometimes various parameter adjustment boxes in the right of the interface should be
concealed to better observe the images. Click the button “
” and such parameter adjustment
boxes in the right of the interface would be immediately concealed. Click the button again to
cancel the concealment.
Measurement
This software could draw, measure and label such figures like “beeline”, “circle”, “ellipse”,
“rectangle”, “angle” and “polygon” in the image.
25
To Next Page
Loading...