Characters
Click the item “Operation-〉Text” in Menu or the button
“
” (or the shortcut key “T”)
and select an area in the image by clicking to enter characters.
Object selection
Click the button “
” in Toolbar, select an object in the image with the left key of mouse
and change the color of the object selected to “Selection Status”.
Figure moving
Select a figure and drag it with the left key of mouse or move it with the “Direction Key” in
the keyboard.
bject
it could be deleted by means
icking t
Delete single o
Select an object by means of the above “Object selection”, and
of cl he button “
” or the shortcut key “DELETE”.
Click
Delete all
“
” to delete all the objects.
Conceal descriptors
Tick the box in front of “Hide Desc” within the ruler setup box and the parameter descriptors
of figures w their parameters would be displayed.
Measurement Examples
an image of circuit board for measurement. Firstly, set up proper rulers; click the
button “
ould be concealed, thus only figures without
Capture
” (marked 1 in the image) in Toolbar and the ruler setup box (marked 2) would
appear in the right of the interface; and in the ruler setup box, the proper measurement units and
precisions (micron, 0.00000) could be set up.
After be measured at first. Measure the length by means
beeline,
the ruler is set up, the length should
of click the button “
” (marked 3) in Toolbar and draw the object to be
measured---the length from one line to another in the circuit board---in the image; then the
ameters 2282.47388 microns.
par of the beeline would appear beside the object, and the length is
27
To Next Page
Loading...