AIPAS AIPAS-A2 - LCD Display Controls

LCD Display Controls LCD Display Controls
Operation Directions
18 19
To prevent serious injury or death, DO NOT change settings excluded from the table. Chang-
ing setting not listed in the following table may cause your bike to stop working properly. If
you need the default setting values of settings not listed, contact Aipas eBikes. DO NOT ride
your bicycle until the default settings have been restored.
Do not tamper with your bicycle. Tampering is defined as removing or replacing any original
equipment or modifying your bicycle in any way that may change its design and/or operation.
Such changes may seriously impair the handling, stability, and other aspects of the bicycle,
making it unsafe to ride. Tampering can void the warranty and render your bicycle non-com-
pliant with the applicable laws and regulations. Aipas eBikes is not responsible for any direct,
incidental, or consequential damages, including, without limitation, damages for personal
injury,property damage, or economic losses due to tampering.
To change display settings, hold the plus (+) and the minus (-) buttons simultaneously to enter
into the Settings Menu. Press the button to toggle between each numbered setting. To adjust
the value of each setting, click the plus (+) and the minus (-) buttons as needed.
There are 21 settings (P01-P21). You should only change the settings listed below.
NOTE: The trip meter, as well as maximum and average speed will reset when the bicycle is
powered OFF.
Turn the bicycle ON/OFF
Increase PAS Level
Decrease PAS Level
Press and hold button
Press plus (+) button
Press minus (-) button
Turn lights ON/OFF
Horn sound/stop
Press the button to turn on,
Press the button to turn off.
Toggle Odometer, Trip A, Voltage,Current,
Trip Timer (TM)
Max Speed and Average Speed
Press and hold the plus (+) button and )
button simultaneously to toggle between
the speed meter, max speed and average
speed.
Press the button, and the horn will
sound. Release it, and the horn will stop.
Press button
LIGHT BUTTON
HORN BUTTON
ODO: Total mileage of the eBikem.
Walk: Walking mode;
Cruise: Cruise control mode;
TM: The total power-on time of the display
TRIP:Distance traveled during the current trip
VOL: Curent working voltage ofthe battery
CUR: Current working current of the battery
Error: An error has occuired with the eBike
(see error code table for details)
POWER BUTTON
PLUS BUTTON
MINUS BUTTON
Speed
&PAS Level
Battery Indicator
eBike Work Mlode
Multifunction
Display Area