EasyManua.ls Logo

AIPAS AIPAS-A2 - Electrical Components

AIPAS AIPAS-A2
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Warning Messages Warning Messages
26 27
Electrical Components
Always turn lights ON for your safety, especially when riding at night or in low visibility situations.
Tips to Increase Range
To get the maximum range out of each battery charge, there are some simple things you can do:
Battery
Only place the battery pack on clean surfaces. Avoid getting dirt, e.g.sand or soil, in the charging
port and contacts.
Do not charge or use a battery pack if it is damaged. Contact AipaseBikes to order a replace-
ment.
When unlocking and removing your battery pack from the frame, take care that it does not slide
out while the bicycle is folded. If your battery impacts the ground and is damaged, discontinue
use and contact Aipas eBikes immediately.
Top Speed
Your Aipas eBike ships with a maximum speed set at 20 miles per hour (mph). This means it is a
Class 2 electric bicycle in states that recognize three classes of eBikes. In most states that only
recognize eBikes generally, the 20 mph top speed is legal for use on public roads.
Ride within your limits to prevent serious injury or death. Riding at higher speeds poses an
increased safety risk. ALWAYS wear a helmet and obey the rules of the road.
Range Estimates
The range the bicycle can go on a single battery charge can vary significantly between riders,
terrain, wind conditions, user input, and additional cargo weight. The following table shows
estimates of potential ranges riders may expect in different conditions.
Set the display brightness such that you can adequately see important information like speed or
warning symbols. Display brightness that is incorrectly set can result in dangerous situations.
Do not allow yourself to be distracted by the display. If you do not concentrate on the trac
around you, you risk being involved in a crash. If you want to change any settings other than the
PAS level, always stop before changing the settings or display.
NOTE: This setting represents the top speed in kilometers per hour. For Class 2 performance, this
speed setting must not exceed 20 mph (32 km/h). For Class 3 performance, this setting will be
set at 100, indicating the bike has been completely unlocked to enable speeds of up to 28mph.
Ride at a lower PAS level
Use lower PAS levels and pedal when climbing hills
Pedal when starting from a standstill
28 mph
20 mph
20 mph
20 mph
20 mph
Throttle not allowed
3
1
2 (Default)
Pedal Assist Speed LimitClass
Throttle Speed Limit
All tests were performed with:
Flat ground
Few bumps
Little to no wind
Top speed set to 20 mph
Few starts and stops
No additional cargo
Temperature ~75°F
Rider weight ~180 lbs
CST BFT tires at ~30 PSI