EasyManua.ls Logo

AIPAS AIPAS-A2 - Suspension Fork; Mechanical Disc Brakes

AIPAS AIPAS-A2
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Functions Functions
22 23
7-Speed Gear System
To turn lights ON: Press the button to turn on.
To turn lights OFF: Press the button to turn off.
Your Aipas eBike comes with a 7-speed freewheel. The freewheel is the cluster of sprockets on
the rear wheel of your bicycle. While pedaling in 1st gear (lowest gear using the largest sprocket),
it will be easier to pedal up hills. In 7th gear (highest gear using the smallest sprocket), it will be
easier to reach higher speeds on flat or downhill terrain.
Suspension Fork
Please check to ensure your suspension forks are properly adjusted for the terrain and your
weight. The black knob does not have a function. The suspension fork will affect the handling of
the bicycle, primarily when going over bumps and stopping. In some situations, it may be advan-
tageous to lock the suspension so it is fully rigid.
How To Use Pedal Assist
Pedal Assist (PAS) functions only when you are pedaling. If you do not pedal, the PAS will not
activate. The motor output always depends on your pedaling and the PAS level you have set.
PAS automatically switches off at the maximum speed set for your Aipas eBike (up to 28 mph).
When the speed falls below the maximum set speed, PAS automatically becomes available
again.
You can also use your Aipas eBike as a normal bicycle without assistance at any time, either by
turning off the display or by setting the PAS level to 0. PAS will not function if the battery is
discharged.
When the bicycle has not been used for 10 consecutive minutes, the display will automatically
shut down. The PAS and throttle features will no longer work when the display is OFF.
Front and Rear Lights
Your Aipas eBike comes with integrated front and rear lights.
Throttle
The right handlebar features a twist throttle.
Mechanical Disc Brakes
Your Aipas is equipped with mechanical disc brakes.
Check that the Pedal Assist (PAS) level is set above 0, then twist the throttle back slowly to
achieve your desired speed and acceleration.
Increase stiffness:
Turn the blue knob clockwise towards the"lock" direction indicated.
Reduce stiffness:
Turn the blue knob counterclockwise towards the"open" direction. indicated.
Fully lock suspension:
Turn the knob clockwise towards the"lock" direction indicated until it cannot be turned further.
To brake the front wheel:
Pull the left brake lever to activate the front brake.
To brake the rear wheel:
Pull the right brake lever to activate the rear brake.
WARNING!
WARNING!
Push the plus (+) button to shift up
Push the minus (-) lever
forward to shift down