Thinks To Know Before The Ride Thinks To Know Before The Ride
28 29
Things To Check
Pull the brake levers to make sure your brakes are working properly and adjust them if necessary.
NEVER exceed the maximum total weight limit of 330 lbs. (150 kg). The rear rack can hold a
maximum of 75 lbs. (35 kg). As an example, if you have 40 lbs. (18 kg) of cargo, then the maxi-
mum weight of the rider would be 290 lbs. (131 kg)
Only carry the cargo you need. More weight will drain the battery faster and affect how the bike
handles.
Ensure all components are properly secured.
Make sure your battery is fully charged.
Please secure your helmet.
Safety Tips
The acceleration of your eBike might be faster than anticipated and may feel unadaptable at
first. Before your ride, Please use the lowest level of pedal assist (PAS 1) and become familiar with
the operation of your Aipas eBike by practicing starting, stopping, cornering, and navigating
obstacles in a safe environment away from other bicycles, pedestrians, and/or vehicles. You
should also pay particular attention to terrain conditions as you may approach obstacles faster
than expected.
How To Start And End Your Ride
The Pedal Assist may be activated as soon as you step onto the pedals and the bicycle is in
motion. ALWAYS be seated on the bicycle and engage at least one brake before starting to pedal.
DO NOT place one foot on a pedal then throw your other leg over the bicycle or your eBike could
accelerate unexpectedly.
Note:Exercise extreme caution when using the twist throttle. When at a complete stop with
the bicycle power ON, be careful not to twist the throttle, or the bicycle could accelerate and
cause you to crash.
Do not engage in Walking Mode when riding or sitting on your Aipas eBike. Holding the minus
(-) button will engage the motor up to a walking speed.
Check your eBike to ensure the front axle, the rear axle, the handle-bars, and the seat are
secure.
Check that both the handlebar latch and frame latch are fully closed and locked.
Check the tire pressure of both wheels.
Insert key and turn counterclockwise to the ON position. The key will be parallel with the
frame and you will not be able to remove the key from the battery pack.
1.
Hold down the button located on the left handlebar until the display comes on.2.
Select a Pedal Assist (PAS) level using the plus (+) and minus (-) buttons. PAS 0 provides no
motor assist. PAS 1 is the lowest level of assist and PAS 5 is the highest level of assist.
3.
When the bicycle is at a complete stop, press and hold the button to turn the display OFF. This
ensures the motor will not activate until the display is turned ON again and you are ready to
ride.
4.
To Next Page