Warning MessagesFunctions
24 25
Walk Mode
Electric bicycles are heavier than bicycles. To make walking the bicycle easier, your Aipas is
equipped with Walk Mode, which can be toggled on or off in the settings menu. Walk Mode may
be subject to local regulations. Check your local regulations to determine if it is allowed.
Frame
Never modify your frame or bicycle in any way as this could cause serious injury or death. Do not
sand, drill, file, or remove parts from your bicycle. Do not install incompatible components or
hardware.
Motor & Electric System
Do not open the drive unit yourself. The drive unit must only be repaired by qualified personnel
using only original parts. This will ensure that the safety of the drive unit is maintained.
Brake System
ALWAYS apply the right brake lever (rear wheel) before and during the use of the front brake.AL-
WAYS apply even pressure to both brake levers when blowing down or stopping. If only the front
brake is applied while slowing or stopping quickly, you may be ejected over the front handlebars.
Before riding, check to ensure brake levers do not touch the handlebars when fully applied, If
either lever touches the handlebars screw or unscrew the barrel adjuster to increase tension in
the brake cable. If this does not fix the problem, take your bicycle to an experienced bicycle
mechanic for further adjustment.
Disc brake rotors will become hot during use and will stay hot for a short period after use. To
prevent burns, do not touch the disc rotor right after use.
Unauthorized opening of the drive unit will render warranty claims null and void.
Under extreme conditions, such as continuously high loads at low speeds when riding up hills or
carrying loads, parts of the motor can reach high temperatures.
All components fitted to the drive unit and all other components of your Aipas eBike PAS system
(e.g. chaining, chaining receptacle, pedals) must only be replaced with identical components or
components that have been specifically approved by Aipas eBikes. This should help protect the
motor from overloading.
Always remove the battery pack from your Aipas eBike before beginning work (e.g. inspection,
repair, assembly, maintenance, work on the chain, etc.), transporting it with a car or on an
airplane, or storing it. Battery pack removal should prevent unintentional activation of your Aipas
eBike.
Do not make any modifications to your Aipas eBike or attach any other products that might
increase the performance of your Aipas eBike. Doing so will generally reduce the service life of
the system and risks damaging the drive unit and the bicycle. You also run the risk of losing the
guarantee and warranty claims on the bicycle you have purchased.
Cruise Control
Cruise control on your Aipas works similarly to cruise control on a car. The bike will try to main-
tain a speed based on the position of the throttle when cruise control is activated. For example,
if the throttle is twisted all the way from its resting position (to a position that would normally
maintain 20 mph) and the minus button is held, cruise control will be activated and set at 20
mph. Even if the bike is currently going slower than 20 mph, the bike will try to accelerate and
maintain that speed because it was set based on that throttle position.
Hold down the minus (-) button on the display control pad and the motor will engage at a speed
similar to a slow walk.
NOTE: When Walk Mode is active,"Walking" will appear on the display.
To activate:
Hold the minus (-) button while twisting the throttle.
To cruise at low speeds, only slightly twist the throttle and hold the minus (-) button.
To activate:
Pull either brake lever to disengage Walk Mode OR press and hold the minus (-)button on the
display control pad.
To deactivate:
NOTE: When Cruise Control is active, “Cruise" will appear on the display.
Pull either brake lever to disengage Cruise Control.
To deactivate:
To Next Page
Loading...