AIPAS AIPAS-A2 - Functions

FunctionsLCD Display Controls
FunctionSetting Default Explanation
BrightnessP01 2
Backlight display brightness.The darkest
level is 1 and thebrightest level is 3.
SleepP04 10
Tire SizeP06 22
Speed LimitP08 32
Distance UnitsP02 1 0:KM; 1: MILE
20 21
LCD Display sleep timer. The default setting
will turn the display OFF after it has not
been used for 10 minutes.
Range is 0-100.The value represents the maximum
operating speed of your Aipas eBike in km/h. For
example,a value of 25 indicates the maximum
speed will notexceed 25 km/h. Drive speed is
maintained at this set value. Any value above 45
will fully unlock the bike’s speed, which equates to
up to 28mph. Margin of error: 3 km/h
Used to compute speed and distance
traveled.
Throttle Zero StartP09 0
0: Throttle active from standstill.
1: Throttle active only whenalready moving.
PAS SensitivityP11 3
PAS StrengthP12 1
Restore Factory
Settings
P16 N/A
Walk Mode ToggleP21 0
Mode ToggleP10 2
0: PAS Active, Throttle Inactive
1: PAS Inactive, Throttle Active
2: Both PAS and Throttle Active
When set to higher numbers,the motor will
come on stronger.Lower numbers will be
more gentle.
Press the (-) button for five seconds to
restore factory settings.
0: Walk Mode disabled
1: Walk Mode enabled
When set to higher numbers, it will take more
crank rotations for the motor to turn ON.
Lower numbers will take fewer crank
rotations to turn the motor ON.
Tightening Torque
Bottom Bracket
Brake Caliper Mounting Bolts
Brake Lever Clamp Bolts
Crank Bolts
Disc Rotor Mounting Bolts
Fender Mounting Bolts
Headlight Mounting Screw
Headset Parts
Rear Derailleur Mounting Bolt
Rear Derailleur Cable Clamp Bolt
Pedals
Kickstand Mounting Bolts
Rear Rack Mounting Bolts
Seat Rail Binder
Shifter Clamp Bolt
Spokes
Stem Clamp Bolts
Stem Plate
Torque Arm Bolt
Wheel Axle Nuts
Seatpost Clamp
60 Nm
7 Nm
7 Nm
45 Nm
7 Nm
6 Nm
7 Nm
34 Nm
8 Nm
4 Nmt
10 Nm
10 Nm
7 Nm
20 Nm
5 Nm
160-180(KGF)
10 Nm
7 Nm
7 Nm
40 Nm
9 Nm
Spec