Troubleshooting Maintenance
36 37
Error Codes
The components of your Aipas eBike are continuously monitored automatically. If a fault is
detected, the error code will appear on the display.
You should have your bicycle maintained at regular service intervals at your local bicycle shop.
NEVER open any of the components, including the battery, display, motor, or PAS sensor. Service
should only be performed by a bicycle repair shop.
Always remove the battery pack before performing any bicycle inspection, maintenance, or
repair.
If you suspect that something is loose, do not ride your bicycle. All nuts, bolts, and screws require
the proper tightening force. Too little force and the fastener may not hold securely. Too much
force and the fastener can strip threads, stretch, deform, or break. Either way, incorrect tighten-
ing force can result in component failure, which can cause you to lose control and crash. Take
your bicycle to a bicycle repair shop for service.
Do not paint any components of your Aipas eBike as they may cause premature failure of the
component.
Do not submerge your Aipas eBike or its components in water use a pressure washer to clean it.
Always observe the operating and storage temperatures of your Aipas eBike and its components.
Protect motor, display, and battery pack against extreme temperatures (e.g. from intense
sunlight without adequate ventilation). Extreme temperatures can damage components (espe-
cially the battery pack). Please have your Aipas eBike serviced at least once a year.
1. Charge the battery until the light onthe charger turns
from red to green.This may take up to 8 hours.
2. Insert key in the battery and turncounterclockwise to
the ON positionor until the key is parallel with theframe.
Then press and hold the bbutton to turn ON.
3. Follow the cable coming from thedisplay down to the
quick plug. Youmay need to unravel some of theplastic
wrapping to access it. With aquick pull (do not twist),
unplug thequick plug, inspect both sides of theplug, and
reconnect by lining up thearrows on both ends. After
checkingthe quick plug, press and hold the bbutton on
the display control pad toturn on.
Issue Most Common Solutions
Bicycle will not turn ON.
Pedal assist or throttle do
not work.
1. Check that the PAS level is setbetween 1-5.
2. To test if PAS is working, do notoperate throttle.
3. To test if the throttle is working, donot pedal.
4. Check all quick plugs.
Error Code
E003
E006
E007
E008
E009
E010
E011
Meaning
PAS Sensor Fault
Battery Under-voltage
Motor Fault
Throttle Fault
Controller Fault
Display,Communication,Reception Failure
Display,Communication,Send Failure
Most Common Solution
Check PAS quick plug
Fully charge battery
Check motor quick plug
Check throttle quick plug
Check controller connections
Check display quick plug
Check display quick plug
Note: Our warranty does not include any maintenance fees
To Next Page