EB AT-RP-4GU EN 9-11
Service
− Holding the stop screw (02) in position, tighten the stop
adjustment nut (04) to lock the stop screw (02).
Î Refer to the section 15.2 ‘Tightening torques‘. (Table 15.3)
Open position
− With the actuator in open position (90° position), screw or
unscrew the left stop screw (02) 1 turn at a time until the
desired stop position is achieved.
− Holding the stop screw (02) in position, tighten the stop
adjustment nut (04) to lock the stop screw (02).
Î Refer to the section 15.2 ‘Tightening torques‘. (Table 15.3)
− Regulate the extra travel stop adjustment, if any.
Î Refer to the data sheet [T.D.S. 2.1.5.1.1] for extra travel
stop adjustment.
9.5.7 Mounting the actuator over the valve
Refer to the section 5.3 ‘Mounting the actuator over the valve‘.
To Next Page
Loading...
