Heatless Regenerative Desiccant Air Dryer | AHLD Series
5
Notice: For optimum performance, use only Aircel replacement parts.
Notice: For information and notes specific to custom designed and built dryers, reference the drawing package
provided with the unit. See warranty on manual back cover for custom engineered products.
NOTICE
Throughout this manual, signal words are present to advise of safety
precautions and/or standard practices. Obey these signal words as dened
below:
DANGER! - Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING! - Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION! - Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
Notice: used to address practices not related to personal injury.
WARNING!
GENERAL SAFETY PROCEDURES:
• Improper installation, operation, or maintenance may contribute to conditions in the work area or facility that could
result in personal injury and product or property damage. Check that all equipment is properly selected and sized for
the intended use.
• Consult and comply with national and local codes relating to fire or explosion and all other appropriate codes when
determining the location and operation of this equipment.
• Safe and efficient operation of the unit depends on proper installation.
• Authorities with jurisdiction should be consulted before installing to verify local codes and installation procedures. In
the absence of such codes, install unit according to the National Electric Code, NFPA No. 70-latest edition.
• A qualified installation and service agent must complete installation and service of this equipment.
• DO NOT weld on / to pressure vessel or modify it in any way.
• DO NOT remove, modify, or adjust protective or safety devices.
• Lock out power supply and depressurize system before performing maintenance or service work.
• DO NOT operate the equipment with the control panel door open.
To Next Page
Loading...
