30 AS-D+—AS-P Series Instruction Manual
AirSep Corporation
Air Hose
Red color rubber hose supplied for the inlet connection of the oxygen generator.
Oxygen Hose
Stainless steel braided hose supplied for the outlet connection of the oxygen
generator.
Regulator Kit/Assembly
This assembly contains the following items:
■ Pressure Regulator for Product Oxygen
■ Bacteria Filter*
■ Pressure Gauge
■ Vent Valve with Muffler (Helps purge low concentration oxygen
during initial start-up. Please refer to chapter 6 for details)
■ Oxygen Concentration Sample Port*
■ Low Concentration Shut-Off Valve*
* Items supplied based on the type of regulator kit ordered.
This assembly should be mounted at the outlet of the oxygen receiver.
Magnalube-G
Grease for lubricating the feed air regulator
Regulator Support Bracket
As the name suggests, regulator support bracket is used to support the pressure
regulator assembly for the product oxygen.
In addition to the starter kits, few other accessories are also available. These are
listed below.
To Next Page
Loading...
Need help?
General
