AS-D+—AS-P Series Instruction Manual 33
AirSep Corporation
5.0 Installation
5.1 HANDLING AND UNPACKING
AirSep Corporation ships the oxygen generator on a covered skid. The skid also
includes an accessory box (only in AS-D+ through AS-L Models) containing all the
accessories for the unit and an instruction manual needed to install the unit properly.
The oxygen receiver, if supplied, is shipped on a separate skid.
To unpack the oxygen generator, follow these guidelines:
1. Inspect the shipping container and open it immediately upon receipt.
2. If the exterior packaging is severely damaged, note it on the freight bill
before you sign it.
You must submit a damage claim within 24 hours of receipt. In the
case of concealed or hidden damage, a claim must be led within
15 days of receipt. Only the consignee can le a claim. The
AirSep Product Warranty does not cover shipping damage.
3. Unpack the unit and remove any protective wrapping and packaging.
Retain the carton and packaging to facilitate the future shipping and
transporting of the unit.
4. Place the unit in an upright position and thoroughly inspect the
enclosure and all the external components (e.g., control panel) for
damage.
5. Open the control panel and inspect the interior for loose or damaged
parts.
To prevent electrical shock, make sure the main power supply is
disconnected when you remove the enclosure, inspect the internal
components, and install the oxygen generator and oxygen receiver.
6. Inspect all the wiring to ensure that no wires are broken and no push-
on connector is off its terminal. If a wire is disconnected, reconnect the
wire according to the electrical schematic.
7. After inspecting the interior, close the control panel on the unit.
8. Locate the instruction manual inside the accessory box. Read the
entire manual before installing and operating the unit.
To Next Page
Loading...
Need help?
General
