What to do if AJ Storage has inverter short circuit protection?
If your AJ Storage unit is showing an inverter short circuit protection error, carefully inspect the load connection to identify and fix any short-circuit issues. After addressing the fault, power the unit back on to resume load output.
How to fix bypass overload protection on AJ PowerCube P5A?
To resolve bypass overload protection or inverter overload protection on your AJ Storage system, try reducing the amount of power being used by your equipment. Then, restart the unit to restore load output.
How to fix no display on AJ PowerCube P5A Storage screen?
If there is no display on your AJ Storage screen: - First, check that the battery air switch or the PV air switch is closed and in the 'ON' state. - If the switch is on, press any button on the screen to exit sleep mode.
What to do for battery over-voltage protection in AJ Storage?
If your AJ Storage experiences battery over-voltage protection, measure the battery voltage to see if it exceeds the rated voltage. If it does, turn off the PV array air switch and Mains air switch.
How to check PV over-voltage in AJ PowerCube P5A?
To check for PV over-voltage in your AJ Storage system, use a multimeter to verify if the PV input voltage exceeds the maximum allowable input voltage.
How to resolve battery under-voltage protection on AJ PowerCube P5A Storage?
To resolve battery under-voltage protection on your AJ Storage, charge the battery until its voltage returns to the low voltage disconnection recovery voltage.
To Next Page
General